1. Before each program is processed, strictly verify that the tool is consistent with the program.
2. Make sure the length of the tool and whether the tool head is suitable when installing the tool.
3. Do not open doors in machine tool operation to avoid flying knife or work piece.
4. During the process, the operator must stop immediately, such as pressing the "emergency stop" button or the "reset key" button or setting the "feed rate" to zero. 5. It is necessary to maintain the same area for each tool alignment in the same work piece to ensure the accuracy of the CNC machining center operation rules when the tool is connected to the tool.
5. If too much machining allowance is found during the machining process, the X, Y, Z values must be cleared to zero and then manually milled and then rolled back to "zero point" to run it by itself using a "single segment" or "pause". The value of X, Y, Z must be cleared to zero and then rolled back to "zero point" for its own operation. 7. Operators must not leave the machine tool or check the machine operation status regularly. If you want to leave midway, you must appoint the relevant personnel to check it.
8. Clean the aluminum slag in the machine before injecting oil into the knife to prevent the aluminum slag from absorbing oil.
9. Try to blow with gas in the roughing procedure and oil injection in the smooth knife program.
10. When the workpiece is off the machine, the burrs must be cleaned and removed in time.
11. After work, the operator must make a timely and accurate hand-over to ensure that the follow-up processing can be carried out normally. 12. Before shutting down, make sure the tool store is in the original position, the XYZ axis is in the center position, turn off the power supply and the main power supply in turn on the machine tool operating panel. 13. In case of thunderstorm, the power supply must be cut off immediately.
In addition to the above points, there are still a lot of things that need to be paid attention to from time to time, the system should be paid attention to, the machine should also pay attention to maintenance, in fact, most of the time, the machine will be broken, to a large extent, and the user's operation is inappropriate. Irregular sitting machine maintenance, do not pay attention to check the machine before starting, do not preheat, some companies because of the environment is not good, the machine for a long time in the dark wet, dust, oil and various other chemical liquids corrosion, In fact, if we deal with these problems in a timely manner, our machines will definitely last a long time, and the processing accuracy and performance of the machines will be as long as they are new. The loss will also be greatly reduced, and the frequency of replacement of the parts will be reduced, saving a lot of time and cost
If any abnormal phenomena occur during operation, please contact the manufacturer in time to avoid unnecessary loss.
If you want to know more about best cnc turning products with aluminum and 4 axis cnc machining aluminum parts. please email below.
steven@smilecnc-china.com (our sales manager)

