Some Key Points To Improve The Quality Of CNC Machining Workpiece

Apr 12, 2019

Leave a message

1. Reasonable use of CNC to process cutting tools

Processing steel, copper knife should be strictly differentiated use, the amount of smooth knife should be reasonable, so that the smoothness of the workpiece and tool life will be better.

  

2.Before cnc turning machining, the calibration table is used to detect whether the tool swings within the allowable tolerance range. The knife head and lock tip should be cleaned by air gun before machining, or cleaned with cloth before loading the knife. Too dirty has a certain effect on the precision and quality of the workpiece.

 

3, when clamping, pay attention to see clearly the name of the CNC machining workpiece and program list, whether the model is the same, whether the material size is matched, whether the clamping height is high enough, the number of cards with calipers.

 

4, The program list for cnc machining processing should be in line with the direction of the reference angle indicated by the mold, and then check whether the 3D map is correct or not, especially the work piece that has already drilled the water, and make sure that the 3D diagram is consistent with the water transported on the work piece. If unknown, timely feedback to the programmer or craftsman to the next 2D drawings, to see if 2D and 3D reference angle is consistent.

 

5.The program list for cnc milling processing documents should be formalized, including die number, name, program name, processing content, tool size, tool feed, especially the safe length of tool mounting, the reserved amount of each program, and the light knife, should be clearly stated. R surface and plane to meet the place, should be noted on the program list, operators in processing to improve the 0.02~0.05MM first processing, gong when a few knives stop to see if smooth, touch with the hand if the grade, if not down again.

 

6. Before processing, you should understand the contents of the program list processed by CNC. There must be 2D or 3D drawings on the program list, and the six-sided data "X length, Y width, Z height" should be marked with "X length, Y width, Z height," and if there is a plane, the "Z" value should be marked. Operators can easily detect whether the data is correct after processing. Tolerance data should be indicated if there are tolerances.

 

7. The machine tool processing speed operator shall be strictly controlled, and the speed of F and S main shaft shall be adjusted reasonably well, and the relative S main shaft shall be accelerated when the speed of F is high, and the feeding speed in different areas shall be adjusted. After the processing is finished, the inspection quality is not a problem, and the machine can be put down, so that the processing is perfect.

 

If you want to know more about cnc aluminum machining parts and aluminum cnc machining with anodized. please email below.

steven@smilecnc-china.com (our sales manager)

Send Inquiry