The steps of silicone rubber prototypes process by silicone mold vacuum casting

Nov 28, 2018

Leave a message


Knowledge: The steps of silicone rubber prototypes process by silicone mold vacuum casting

Tools and materials used for vacuum casting of resin crafts: release agent, silicone mould, board, cardboard, hot melt glue, agitator, cup, vacuum machine, knife.

1,The mold spray release agent will directly affect the quality of the mold.

2.The treated model is fixed to the treated board, the corresponding cardboard is cut and surrounded by the model, and the gap between the board and the model is sealed with hot melt glue, leaving a gap of about 1 cm between the paperboard and the model.

3.Take appropriate amount of silica gel, add 2% 4% curing agent, stir well, pour a part into the mold, then vacuum together, pump vacuum to -0.1 MPA.This can prevent bubbles in the made silicone mold. Vacuum time control in 3 minutes, should not be too long.

4.After complete curing, the mold can be opened, the cardboard around the mold is removed, and the extra silicone on the four sides of the shear is modified.

5.Determine the opening line and cut the silicone plate with the knife. The die line should be zigzag to facilitate the bite of the silicone mold.

6.At this point, the end of the silicone mold manufacturing process, silicone mold 24 hours after the production can be put into use.

silicone mold vacuum casting manufacturer

Send Inquiry