Prototype Surface Treatment-fuel Injection

Mar 12, 2019

Leave a message

  Oil injection is the name of surface coating processing of industrial products, injection processing is generally engaged in plastic oil injection, screen printing, printing processing; EVA, rubber shoes to change color, screen printing. An injector is required to complete the process. According to the demand can choose oil spray matte, semi-matte, highlight, etc.

Why the injection?

  The injection of oil on the surface of the prototype can make it more beautiful. To a certain extent, the effect of oil injection can make consumers have better visual impact and promote consumption. In addition, the injection opponent board and products have a certain protection, taking the metal surface spray paint, metal surface spray is a way to protect the metal from oxidation corrosion. A good coating can be used as a barrier to resist the corrosion medium.

The following five steps are involved in fuel injection processing:

1.The internal stress is easily formed when the annealed plastics are formed, and the stress concentration is easy to crack after coating. Annealing treatment or whole surface treatment can be used to eliminate stress. Annealing is to heat the ABS plastic parts below the hot deformation temperature, that is, 60 ℃, 2 h heat preservation. Because the adoption of this process requires a large amount of equipment investment, we can use the whole surface treatment technology, that is, the solution which can eliminate the stress of plastic parts can be treated with 15-20min at room temperature on the surface of plastic parts.

2.the surface of deoiled plastic parts is often stained with oil, hand sweat and release agent, it will make the coating adhesion become worse, the coating produce crack, foaming and shedding. Oil removal should be carried out before painting. The plastic parts are usually cleaned with gasoline or alcohol. After chemical deoiling, the residual lye on the workpiece surface should be thoroughly cleaned, then cleaned with pure water to dry or dry.

3.The electrical and dust removal plastic products are insulators, the surface resistance is generally about 1013 Ω, easy to produce static electricity. Charged, it is easy to adsorb the fine dust in the air and adhere to the surface. It is very difficult to remove the dust from electrostatic adsorption by general blowing method, and the high pressure ionization air current is used to remove the dust at the same time.

4.the thickness of spray plastic coating is 1520 μ m. After one spray, dry for 15 min, then spray for the second time. A bright surface must also be coated with transparent paint. The coated parts have no effect on the flame retardancy.

  To bake general paint for 20-30 minutes at 150 ~ 180 ℃ for about 20-30 minutes at 60-80 ℃.

  Part of the special paint can be dried in the greenhouse.

 prototype design air conditioner parts small air conditioner

If you want to know more about abs 3d printing sla rapid prototype and PAGF 3d printer service . please email below. 

steven@smilecnc-china.com (our sales manager)

Send Inquiry