
In actual machining, thread types generally include: ordinary single thread, trapezoidal thread, special thread, irregular thread, etc. Among them, ordinary threads are the most widely used, with coarse threads being commonly used for connections, while fine threads are used for connections of thin-walled parts or parts subjected to variable loads, vibrations, and impact loads. They can also be used for fine-tuning mechanisms. When machining ordinary threads, it is important to note that multiple cycles of feed are required during cutting, and each cutting depth must decrease in a certain proportion. If the cutting depth of each tool is the same, the force on the cutting edges on both sides of the thread turning tool will increase sharply with the increase of material cutting rate, leading to a decrease in thread accuracy and tool damage. In the competition, both internal and external threads are relatively common, and the machining difficulty is generally small. The main focus is on calculating the thread base.
Compared to ordinary threads, trapezoidal threads have longer lengths, larger pitches, deeper cutting depths, greater cutting forces, and higher precision requirements, making machining more difficult. The general methods for thread cutting on CNC lathes include straight cutting, oblique cutting, staggered cutting, and rough groove cutting.
(1) Straight forward method. When cutting on a lathe, the Z-axis moves in a straight line without changing, while the X-axis feeds one cutting depth in steps. The characteristics are convenience, speed, and high efficiency. Usually, ordinary threads with smaller pitches can be used. However, due to the simultaneous cutting of both edges of the turning tool, as well as poor chip removal and high stress, the turning tool is prone to wear and tear, and the chips will scratch the surface of the thread.
(2) Diagonal advancement method. At the same time as the Z-direction feed, there is also a linkage in the X-direction, forming a diagonal feed method. At this time, the thread turning tool always has only one cutting edge involved in cutting, and the chip removal is smoother. The force and heat generated are smaller than those of the straight-line method. However, when the thread depth is deep and the pitch is large, it is easy to produce a stabbing phenomenon.
(3) Cross cutting method. Thread turning tools are inserted in a staggered manner parallel to the left and right tooth sides, until the tooth base is reached. Very suitable for cutting large thread threads, but programming is more complex.
(4) Rough slotting method. First, use a groove cutter smaller than the width of the thread turning tool to roughly cut a groove, and then use a thread turning tool for thread processing. Large pitch threads are often used, but operation and programming are extremely cumbersome.

